Wall control for brightness & color temperature | 1 zone
Available, delivery time 3-5 days
- for LK55 series receivers
- Controllable zones: 1
This wall controller can be used to control the brightness and color temperature of an LED installation, e.g. for strips with mixed warm white and cool white LEDs. The RF radio version does not require direct visual contact between remote control and receiver. Suitable drivers/receivers can be found in our universal series LK55.
The wall control works with a push-poti:
- Press once: light is switched on/off
- Press twice: Switch between brightness and color temperature control. The rotary control can then be used to set brighter/darker or warmer/cooler in each case.
Note: The brightness always remains about the same when changing the color temperature. With a medium color temperature, warm white and cool white LEDs are only controlled with about 50%, so that you can always adjust brightness and color temperature completely independently.
The range of the radio signal is up to 30m. Visual contact is not necessary. Solid walls made of concrete, brick or similar naturally weaken the radio signal.
Combination with switch series of well-known manufacturers
The housing frame of the controls measures 86x86mm with a depth of 12mm. In case you want to combine the wall control with light switches, sockets etc., the following switch series are similar in design and dimensions:
- MERTEN M-Plan
- GIRA E2 (flat installation)
- JUNG Serie A Creation
- KOPP HK i8
Check the exact dimensions directly with the manufacturers.
Combination of controls & drivers
One controller can control any number of drivers and up to 8 wall controllers can address the same driver. Thus, for example, wall controllers can be placed at several locations in the room or, if necessary, combined with classic hand-held remote controls.