Mini Dimmer

This mini LED dimmer is only 10mm wide and can be installed, for example, directly with in an aluminum profile. At the point where the spring of the dimmer touches the profile cover, the light can be switched and dimmed by touching the cover with your finger. A short touch switches the LED light on and off. A long touch dims the LED light up and down - always alternating. The spring reacts sensitively even through the cover. A small LED inside the spring marks the appropriate place for the touch well, even with opal covers. The mini LED dimmer remembers the last dim setting even when power is lost, so you can combine it with a normal on/off switch.  Dimensions: approx. L50 x W8 x H10mm  Usable for profiles with an inner height (distance to cover) of min. 5 - max. 10mm.

This mini LED dimmer is only 10mm wide and can be installed directly in an aluminium profile, for example. It works with a wipe sensor so that the light can be switched and even dimmed with a simple hand movement at a short distance (max. 4cm) from the sensor.If you wipe your hand past the sensor, the light is switched on. If you hold your hand in front of the sensor, the light is dimmed up and down. Always in alternation. No profile cover must be installed above the wipe sensor. If necessary, drill a sufficiently large hole in the cover so that the wipe sensor can work properly. Attention! The mini LED dimmer with wipe sensor does NOT remember the last dim setting in case of power loss.  Dimensions: approx. L45 x W10 x H8mm 

This mini CCT controller is only 11mm wide and can, for example, be installed directly in an aluminum profile. At the point where the springs of the controller touch the profile cover, the light can be switched, dimmed and changed in color temperature by touching the cover with a finger. With spring 1, a short touch switches the LED light on and off. A long touch dims the LED light up and down - always alternating. With spring 2, the color temperature of the light is changed - assuming a corresponding CCT LED strip. The springs react sensitively even through the cover. A small LED inside the spring marks the corresponding spot for touching well even with opal covers. The mini CCT controller remembers the last setting even in case of power loss, so you can combine it with a normal on/off switch.  Dimensions: approx. L48 x W11 x H10mm  Usable for profiles with an inner height (distance to cover) of min. 5 - max. 10mm.

This mini LED dimmer can be easily connected between power supply and LED strip and allows convenient dimming via a large rotary potentiometer. In the final position the LEDs are completely switched off. Dimensions: approx. 70 x 35 x 35mm (plus cable) PWM frequency: approx. 1,200 Hz Scope of delivery: 1x Mini dimmer LK82