RGB-Cable 3x0,5mm², 1x 1,5mm² - green

This cable is specially designed for use with RGB solutions. The problem that the common connection is always loaded with 3 times the current is thus solved. In addition, the cables are kept accordingly RGB-colored and thus safe to connect.

Scope of delivery: RGB cable - length according to your quantity specification

Please enter the desired quantity as item number. The delivery is usually made as one piece. If this is not possible for technical reasons, you will be informed in advance.

Note

It can be difficult to solder the common positive wire with 1.5mm² cross-section to the sometimes quite narrow solder pads of the LED strip. 2 solutions are available here:

1. after you have stripped the 1.5mm² wire, cut off about half of the individual copper wires again at this end. The now significantly reduced cross-section of the cable is much easier to solder to the LED strip.

2. take a short piece (10cm) of wire with a smaller cross-section, e.g. 0.75mm². Solder this to the LED strip and then connect it to the 1.5mm² positive wire of the RGBW cable. For the connection, you can use a WAGO clamp or you lead both cables into a wire end sleeve, crimp it and (before!) slide a heat shrink tube over it for insulation.

A reduced cable cross-section is unproblematic for the short distance.

Technical data:

3 cores 0,5mm² | 1 core 1,5mm²
PVC (Y), unshielded according to UDE0207
Temperature range: -30° to +70°C dormant, -5° to +70°C moving
Outer diameter: 6.6mm
Max. Current load: 5 Amps per color (15A total) 
Voltage up to 24V DC